Description
ITEM INCLUDED: 12Pcs 24'' flexible rods One 4'' diameter brush head To clean dryer duct from inside or outside: 1.Unplug dryer and remove dryer duct 2.Remove or open exterior vent hood 3.Connect the brush head to any of the rod(s) and secure each connection with duct tape for added reinforcement 4.Insert brush/rod assembly into wall through duct opening where dryer was connected or through outside vent hood opening. Note:A drill can be attached to the brush/rod assembly for more effective cleaning CAUTION:Rotate brush/rod assembly only in a clockwise.Reversing the direction could cause the brush head or rod(s) to detach inside the duct 5.While turning in a clockwise direction,gently push and pull brush/rod assembly 12'' at a time.Repeat until entire length of duct is clean CAUTION:Never force the brush/rod assembly through the duct.If it should become jammed,pull assembly away from constricted area a few inches (still rotating in a clockwise direction) then slowly push forward 6.Check outside vent hood and inside wall duct opening to ensure entire duct has been cleaned.Remove any lint pushed out from the cleaning process and close or replace hood. 7.Reconnect the dryer duct to the dryer and push dryer back into place 8.Turn on dryer and ensure the air is flowing properly throughout the duct and exhausting air through the outside vent cap
13 Piece Dryer Duct/Vent Cleaning Kit, Lint Remover, Extends up to 24 Feet, Synthetic Brush Head, Use With or Without a Power Drill (12 Rods + 1 Bush Head)
Price is below average
Current Price
$20.98
Average
$23.61
Min Price
$17.98
Max Price
$27.8
Price dynamics
11%
Description
ITEM INCLUDED: 12Pcs 24'' flexible rods One 4'' diameter brush head To clean dryer duct from inside or outside: 1.Unplug dryer and remove dryer duct 2.Remove or open exterior vent hood 3.Connect the brush head to any of the rod(s) and secure each connection with duct tape for added reinforcement 4.Insert brush/rod assembly into wall through duct opening where dryer was connected or through outside vent hood opening. Note:A drill can be attached to the brush/rod assembly for more effective cleaning CAUTION:Rotate brush/rod assembly only in a clockwise.Reversing the direction could cause the brush head or rod(s) to detach inside the duct 5.While turning in a clockwise direction,gently push and pull brush/rod assembly 12'' at a time.Repeat until entire length of duct is clean CAUTION:Never force the brush/rod assembly through the duct.If it should become jammed,pull assembly away from constricted area a few inches (still rotating in a clockwise direction) then slowly push forward 6.Check outside vent hood and inside wall duct opening to ensure entire duct has been cleaned.Remove any lint pushed out from the cleaning process and close or replace hood. 7.Reconnect the dryer duct to the dryer and push dryer back into place 8.Turn on dryer and ensure the air is flowing properly throughout the duct and exhausting air through the outside vent cap
Price will be lower
in next 2 weeks
in next 2 weeks
According to the data, price will be lower in next two weeks, so not waste your money and track better price!
Similar products
