EZ ETCH by Concrete Coatings is a citric acid-based concrete and masonry etcher and cleaner. EZ ETCH is the ideal surface preparation for staining concrete. Use with ELEVATE water-based stain and IMAGIN acid-based stains. MIXING Step 1: Using two gallons (7.58 liters) of clean water in a 5-gallon pail, add the entire contents of EZ ETCH and stir mixture for 5-10 seconds. Step 2: Pour the mixed solution into a plastic sprinkling can. APPLICATION Best results occur when you work in 100 sq. ft. areas (10x 10 feet / 3x3 meters) and complete the process listed below, before moving to the next section. Step 1: Keep the concrete surface damp with water, with no standing puddles. Step 2: Begin pouring the solution onto the damp concrete surface. Step 3: Using a stiff bristle broom, begin scrubbing the floor. Give extra attention to high traffic areas (feet or tires). Do not allow the floor to dry during the scrubbing process. Step 4: Rinse thoroughly while continuing to scrub, ensuring all contaminants are washed away. Step 5: Squeegee off all puddles and excess water. Allow to dry thoroughly. Step 6: Repeat above steps on all areas needed to be etched. Step 7: Once all areas have been etched, rinsed, and allowed to dry, check the dried concrete for surface residue. Using your hand, rub the concrete surface. If a white residue is left on your hands, additional rinsing is required. Rinse the floor and scrub during the entire rinsing. Step 8: When the concrete is free of surface residue and completely dry, you are ready to begin your application of stain, sealer or coating.
EZ ETCH by Concrete Coatings is a citric acid-based concrete and masonry etcher and cleaner. EZ ETCH is the ideal surface preparation for staining concrete. Use with ELEVATE water-based stain and IMAGIN acid-based stains. MIXING Step 1: Using two gallons (7.58 liters) of clean water in a 5-gallon pail, add the entire contents of EZ ETCH and stir mixture for 5-10 seconds. Step 2: Pour the mixed solution into a plastic sprinkling can. APPLICATION Best results occur when you work in 100 sq. ft. areas (10x 10 feet / 3x3 meters) and complete the process listed below, before moving to the next section. Step 1: Keep the concrete surface damp with water, with no standing puddles. Step 2: Begin pouring the solution onto the damp concrete surface. Step 3: Using a stiff bristle broom, begin scrubbing the floor. Give extra attention to high traffic areas (feet or tires). Do not allow the floor to dry during the scrubbing process. Step 4: Rinse thoroughly while continuing to scrub, ensuring all contaminants are washed away. Step 5: Squeegee off all puddles and excess water. Allow to dry thoroughly. Step 6: Repeat above steps on all areas needed to be etched. Step 7: Once all areas have been etched, rinsed, and allowed to dry, check the dried concrete for surface residue. Using your hand, rub the concrete surface. If a white residue is left on your hands, additional rinsing is required. Rinse the floor and scrub during the entire rinsing. Step 8: When the concrete is free of surface residue and completely dry, you are ready to begin your application of stain, sealer or coating.
Price will be lower in next 2 weeks
According to the data, price will be lower in next two weeks, so not waste your money and track better price!
We use cookies to enhance your browsing experience, serve personalized ads or content, and analyze our traffic. By clicking "Accept All", you consent to our use of cookies.
