Description

Why you need the Hafler PH50 Phono Pre-AmpThe Hafler PH50 is a high-performance phono stage for moving magnet (dynamic) cartridges that incorporates a well defined RIAA curve to preserve and transmit the original program material with minimal coloration. Particular attention has been applied to reducing noise, a problem common to the 33 RPM recording chain, resulting in a low -82dB noise floor with greater than 91dB of dynamic range and less than 0.002% distortion. The design begins with a 14 gauge steel casing to shield the low level signals from external magnetic fields and RF contamination. Gold-plated input and output RCA connector pairs are employed that will not tarnish over time, thus optimizing signal flow. Inside, the solid-state circuit and military grade PC board have been optimized by carefully positioning parts for minimal self-noise and cross-talk and then supplemented with a ground plane to reduce susceptibility to RF. An external supply further reduces noise by removing the power transformer from inside the casing. Front panel controls include a power on-off switch and a variable low-cut filter that may be inserted into the signal path when needed. The fully adjustable low cut (high-pass) filter enables the user to reduce low frequencies that can cause resonance and feedback when playing music at higher levels. This helps eliminate both airborne and solidly coupled transmission of vibrations that can disrupt the stylus and cause feedback, rumble and distortion. Compact yet 'plug and play' easy to use, the PH50 follows Hafler's 50 year tradition of building the very finest audio products.FeaturesPhono stages for moving magnet cartridgesUltra low noise transformerless designVariable high-pass filter to eliminate rumblePlug and play easy to set up and use

Hafler PH50 Phono Pre-Amp for Moving Magnet Cartridges

Price is below average

Get price

Current Price

$279

Average

$392.61

Min Price

$265.95

Max Price

$449.99

Price dynamics

29%

Description

According to the data, price will be lower in next two weeks, so not waste your money and track better price!

Product review & video

hey everyone welcome back and today we're going to work on a video so something people have been asking for and that's a preamp and or a photo stage and to use vinyl with one of these tube amplifiers you need one of these things which is a funnel stage and this is a little one i built that it's in a 6 by 14 aluminum chassis and it's got the rca inputs here in the front from the turntable this is the for the ground wire here the outputs are here on the top and it's sitting right here next to my amplifier which is one of the reasons that all my amps have the photo inputs on the side or the rca inputs on the side so i can run short little interconnects that just go from photo stage and over to my amplifier got the power transformer in the back power switch here on the top on the back we got our iec connector that's got the integral fuse in it and i'll show you on the inside of it here in a