Holybro is saving you time and guesswork into making your perfect FPV stack. Comes with the Kakute V2 FC, Atlatl HV vtx, and the Tekko32 4-in-1 ESC.

• 4-in-1 ESC with 30.5x30.5mm mounting holes, supports DSHOT 1200, BLHELI32 firmware
• Added more CAPS to reduce power noise
• 32bit ESC with BLHELI32 firmware
• 4PWM input
• Voltage output (VBAT), ESC Telemetry(TELEM)
• Supports Oneshot / Multishot / Dshot PWM
• Supports damped light
• NO BEC

• Supports 3-6S lipo input
• 35A continuous current, 50A burst
• Mounting holes 30.5x30.5mm
• Size: 55*40*6.4mm
• Weight: 17g

• Two extra UART Ports
• UART4 port for serial camera like the runcam split. (This is not the same as Betaflight Camera Control, which runs of the OSD menu for cameras like the swift, monster).
• UART5 port for ESC telemetry support (for BLheli32 and KISS)
• Through-hole solder pads instead of flat pads for more secure soldering especially for beginners.
• Barometer sensor on board allows altitude hold mode.
• Dedicated I2C pads to connect extra peripherals (like an external compass)

• Supports Betaflight and Cleanflight.
• Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video transmitter channel and power level, all using your transmitter sticks and goggles.
• Soft-mounting built in. The IMU ("gyro") chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.
• New high-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gyro and accelerometer. Can run at up to 32 kHz.
• 2 oz. copper PCB allows up to 120A maximum continuous current.
• Dedicated bootloader button for easy firmware flashing.
• Low-pr