Replacement for Batteries and Light Bulbs Rs-lp04 Projector Tv Lamp Bulb

to properly replace the bulb inside of your DLP lamp you will need the following materials a pair of latex gloves your shopjimmy.com replacement bulb a pair of needle nose pliers a cup to hold your lamp's screws clips and other small items both a flathead and Phillips screwdriver and a piece of tape or sticker to use as a marker remove all housing screws for this lamp there are four housing screws located on two sides of the housing pull the two pieces of housing apart guiding the lamp plug in wires with the bulb remove the bulb from the housing before removing the wire harness from the bulb mark one wire with a piece of tape or sticker and make a note so that you don't forget if you've marked the rear or side terminal connection of the wire harness release the rear bulb terminal by removing the nut and washer with a needlenose pliers release the side bulb terminal by removing the screw