uxcell a15072800ux0846 Hood Shell D-SUB DB15 15-Pin Male Solder Wire End VGA Connector (Pack of 2)

I'm going to go ahead and put the power on ground wires in first ground goes to pin one based on my diagram start the process I strip a short length of the wire in this case black 20 gauge I strip approximately 1/8 of an inch I insert that into the solder cup and if necessary hold it with the second alligator clip in this case it appears I don't need to do that before soldering I clean the tip of my iron with a wet sponge and now I put a very small bead of solder on my iron tip to help me conduct heat from the iron to the component and then hold that against there feed the solder into the opposite side and look for good penetration notice the length of the wire strip it's just enough that the insulation doesn't bottom out against the solder cups so I know that I got full insertion of the wire and yet it's not so much that we have an appropriate amount of bare wire extending to finish th