uxcell Replacement 8 Ohm 1W 40mm Diameter Magnet Midrange Speaker

in the previous video for this build with cartesian drivers i assembled the enclosures drilled and routed a few holes and glued dampening material to the inside you can watch that video with the link above right or in the description below [Music] this week i continue starting with application of the walnut veneer a pva wood glue is applied to the sides and then the veneers clamped between the enclosure and two off-cut plier boards i used some wax paper to avoid any glue to stick to the plywood offcuts i am releasing bold plans for these speakers which you will find on my website at soundblab.net there's a link in the video description below so go check that out once the glue is dry the clamps and ply boards are removed and the excess veneer is trimmed with a flash cut router bit and palm router before veneering the back panel the board is sprayed with a matte black spray can paint sinc