Drive Wheeled Round Stool, Model - 13034

Rough fitting the parts together It's important for all of the parts to line up Testing the hinges Marking the locations of the floor flanges on a scrap board before drilling pilot holes Clamping the template board to the leg in which I will drill the pilot holes to mount the flanges Finishing the pilot holes Mounting the flanges to the legs Test mounting the frame I am using 4/4 quarter sawn red oak to make the seat for the stool Sawing three roughly equal pieces to 18" Gratuitous focus pull shot Planing the rough sawn edges square and flush Gluing-up a panel to cut the seat out of Planing the panel flat Marking the 12" diamater circle that will be the seat Whoops. The break was clean along the glue line, so I simply reglued it after squaring the edge better. Rough cutting away waste Using a coping saw to rough cut out the seat Using a smoothing plane to finish flattening the seat Moun