Gikfun DC 5V Micro Motor with Cable for Arduino DIY Toy EK1833

you have our motor our mosfet a power source a breadboard and then Arduino DC motor all I've done is soldered two green wires onto the end I'm gonna add some tape to the motor just so we can actually see it spinning here this is just a regular old electrical tape this is our mosfet it's similar to a transistor it has a source pin on the left where the current enters a gate pin in the middle this acts as a switch turning on or off the current flow and on the right is our drain pin so where the current exits or drains off there are nine volt battery connections it solder the ends a bit just so we can actually stick them into a breadboard connect their lines that we can plug into so there are five input connections on the top here and then a gap and five inputs connected on the bottom here our connections now so the black negative wire of the 9-volt battery connects to the source of the MO