Datalogic BC9030 BASE/CHARGER, 910MHz, Multi Interface (RS-232, USB, KBD WEDGE), For PM9500. ( Cable and Power Supply Not Included) . . . (154108)

you can perform the initial setup on the PM 8000 series scanners in two ways the first way is to simply scan the gray label with the four digit number provided once you scan this barcode put the scanner in the cradle if the bind is successful you will get a single beep from the scanner if it is not successful you will receive a two beep high-low error tone from the scanner another way to perform initial setup is via the quick reference guide under the heading stand-alone setup first scan the restore power scan default barcode then scan enter configuration you can skip set date and time next scan set radio address and from the number pad that is near the end of the quick reference guide you will need to scan in four digits the value of the digits must be less than 2000 we'll just scan for zeros and then go back to the setup procedure and scan exit and save configuration now scan the bind