Winland Electronics Remote Annunciator

hello everybody this is Jesse from that go tech support and today in this video we're going to go over how to put the panel in configuration mode when adding a remote annunciator to the system we're also gonna go over how to address the remote annunciator once the panel is in configuration mode we're going to start by locating the j1 jumper on the motherboard of the Firelink panel and we're going to take this jumper from the top two pins and move it down to the bottom two pins this jumper is also commonly referred to as the config jumper once this jumper is down on the bottom two pins and the panel is in config mode we're going to remove over to our remote annunciator to address it once we are at the remote annunciate we're going to have to wait for it to say 0 1 at a system all of our remote annunciators come factory addresses number one but that address has been taken up by the contro