Retro Manufacturing LAB-116-117-03-73 Car Radio

Plug the Motor into the face, be sure the "clips" in tightly. Be sure the Retrosound logo is on top. Tuck the ribbon cable into the motor Snap face into slots on motor Attach face with the four small screws. Do Both Sides Now we are ready for Infinimounts. Grab your hardware pack and infinimounts Use machined screws to secure mounts Position the infinimounts, these can be positioned forward or back Tighten both sides and we are ready for shafts Add a shaft nut and washer to each shaft. Do both shafts Now check your alignment we want the brass portion of the shaft in front of the display This will set the rear knobs and face as flush to your dash as possible. Finish and secure each side Gently tighten each shaft nut Plug in each shaft makng sure it is secure There we are, all set and ready for a bezel and to go in our dash.