Pro-Ject RPM 1 Carbon Manual Turntable (Black)

hi I'm Jack from Henley Designs I'm going to show you how to set up your project RPM3 carbon turntable this setup also applies to the RPM 1 carbon turntable from Project Audio Systems. once you've removed everything from the box place the chassis on a level surface the first step is to assemble the turntable firstly place the motorthrough the cut out at one side of the plinth then after removing the protective covers on both the spindle and the bottom of the platter ,place the platter on to the spindle when this is done you can install the drive belt around the small pully rung and around the entire outer circumference of the platter. Use one hand to anchor it while moving the other hand around the platter to install about securely before turning our attention to balancing the tone arm remove the stylus guard and ensure the anti skate is set to 0 now loosen the grub screw on the cou