Label sensor (upper)

the clear label sensors should be set up each time a new label or material is used we're using the sensors existing settings on a different material may not give optimal results for best results always perform a new Auto set for each new material let's look at the physical setup of the clear label sensor first the sensor should be mounted such that the label backer is pressed firmly against the lower silver gap plate this is important for reliable detection secondly notice the arrow on the side label this indicates the position of the sensors sound beam if you are using labels greater than two inches wide or fifty millimeters be sure the edge of the label is inserted at least one inch beyond the arrow if your labels are less than two inches in width Center the label on the arrow once the physical setup is complete there are three auto set modes to setup the clear label sensor for your l