Linear IEI H616 Tel.Master Hub 2 Line 6 Plates

configuring the egx 30 a foreign graving we start by pressing and releasing the select key to set the mode to engrave we then take our engraving stock and place it to the lower left corner of our engraving table on a s10 sheet and remove any protective sheeting that might be on your material to install the nosecone and bearing assembly we want to loosen the brass mounting screw when I take our bearing and nose cone assembly and line up the little tab on the front side of the bearing assembly and push it down we then want to rotate it counterclockwise until it stops and then tighten our mounting screw we then want to take our engraving cutter and place it from the top get our spanner wrench place it on the bottom you then take our engraving tool insert it into the bearing assembly and tighten it down to the spindle from the top to set our XY origin position we want to press the origin po