Description

1.25" probe, small and accurate, Watchdog temperature sensor monitors hot spots in your server or equipment room. Monitor temperature to identify hot spots, and adjust the ambient temperature of your data center to reduce cooling power consumption while increasing efficiency within ASHRAE guidelines. Use these accurate digital sensors to measure temperatures of critical locations in a server room. The small size and weight makes them easy to install where you need them. Stick one in the cabinet inlet and one in the outlet to diagnose air-flow problems. Put one in the A/C vent to detect problems at the source. Accurate to +/-0.5°C. Run them hundreds of feet from the Watchdog monitor. SRT is an improved temperature sensor which is encapsulated with a stainless steel sheath probe sealed with waterproof heat shrink tubing. This provides abrasion resistance and environmental protection against dust and moisture. This allows SRT temperature sensors to carry an IP67 rating, supporting applications related to cold storage and the ability to submerge these probes in water or glycol for liquid temperature monitoring. This is an instant 'Plug & Play' sensor via one of the standard RJ-12 jacks on any Watchdog environmental monitor. Watchdog environmental monitoring appliance cycles through the digital sensors to collect and log new readings. Custom alarms are triggered when a sensor value falls above or below a user-defined threshold. Alarm notifications are sent through email or SNMP. SRT digital temperature sensor comes equipped with a 1.25 inch stainless steel sheath sealed probe with waterproof heat shrink tubing.

SRT-20: Standard-Probe Temperature Sensor, 20-feet

Get price

Current Price

$46

Average

$38

Min Price

$35

Max Price

$46

Price dynamics

17%

Description

According to the data, price will be lower in next two weeks, so not waste your money and track better price!

Product review & video

in order to replace the temperature sensor please follow the drain the spa instructions first reach the temperature sensor harness and pull the piece of insulation foam back along the cord to expose the sensor wall fitting remove the sensor not by turning it counterclockwise the sensor should come out with the nut if not you can pull on it follow the cord and disconnect it from the board pass the nut and the o-ring on the sensor and insert it into the wall fitting hand tighten the nut and install the insulation phone making sure it is covering the whole assembly perform the spa refill instructions